How To Enable WDR3600 IP Passthrough Mode?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How To Enable WDR3600 IP Passthrough Mode?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How To Enable WDR3600 IP Passthrough Mode?
How To Enable WDR3600 IP Passthrough Mode?
2022-06-06 14:55:23
Model: TL-WDR3600  
Hardware Version:
Firmware Version:

How to enable WDR3600 IP passthrough mode to connect to AT&T gateway device?

 

I only see this i the manual:

 

VPN - VPN Passthrough must be enabled if you want to allow VPN tunnels using VPN protocols to pass through the Router.

 

PPTP Passthrough - Point-to-Point Tunneling Protocol (PPTP) allows the Point-to-Point Protocol (PPP) to be tunneled through an IP network. To allow PPTP tunnels to pass through the Router, click Enable.

 

L2TP Passthrough - Layer Two Tunneling Protocol (L2TP) is the method used to enable Point-to-Point sessions via the Internet on the Layer Two level. To allow L2TP tunnels to pass through the Router, click Enable.

 

IPSec Passthrough - Internet Protocol security (IPSec) is a suite of protocols for ensuring private, secure communications over Internet Protocol (IP) networks, through the use of cryptographic security services. To allow IPSec tunnels to pass through the Router, click Enable

  0      
  0      
#1
Options
1 Reply
Re:How To Enable WDR3600 IP Passthrough Mode?
2022-06-07 16:30:06

  @DFW_Mark,

I apologize if I am misunderstanding your question, but from what I can tell: I think you are looking for a way to activate the bridge mode on your modem from AT&T. This will eliminate the wireless network being put out by your gateway and will change its function to simply a modem. This will allow your TP-Link router to provide the wireless signal for your network.

 

The setting for this can be found in the settings for your AT&T Gateway. Depending on the model, these settings could be found in either a WebUI or an Application. Personally, I would recommend looking into another modem and working with your ISP to activate it, as most gateways are provided by ISPs for a monthly fee. 

 

Let me know if I misunderstood what you were looking for.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 487

Replies: 1

Related Articles