Deco S4 ethernet backhaul not working
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco S4 ethernet backhaul not working
Tags:
#Backhaul Method
I have 3 x Deco S4, one is the master, one is connected via WiFi and one should be connected via the Ethernet backhaul. the ethernet cable runs from the master to a TP-Link switch where among others a smart TV and Apple TV are connected. They all work fine but when I connect the the third Deco S4 the whole network goes down, including the the second Deco connected via WiFi (all Deco's go RED)
What could be the problem?
Re:Deco S4 ethernet backhaul not working
Hi, is the network layout like this:
May I know the model number of your TP switch?
And when unplugging satellite S4-2 from the switch, will the other two units recover gradually?
Thank you very much.
Best regards.
Check What's Currently Going on With Deco
Deco Early Access Firmware Open for Test!
Deco APP 3.8.102/3.8.112-Ready for A New Deco Onboarding Experience!
Try to leave a Message if urgent help is required.
