TL-WR710N V1 bricked, any way to save without tearing it open?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
As the title says, TL-WR710N v1 got bricked because I messed up, simple as that. Meant to upgrade DD-WRT and I stupidly used an Openwrt firmware. Now it's bricked, green light comes on. Tried the TFTP 192.168.0.66 method, no luck.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
As far as I am aware, the firmware recovery process for travel routers is no different than the instructions found here: How to Use Firmware Recovery on a TP-Link Router
Are you able to start the process and see a webpage for the firmware?
There are a few older models that do not support the recovery process, so if you follow the instructions and everything fails, I would recommend reaching out to our official support channels for information on next steps.
- Copy Link
- Report Inappropriate Content
As far as I am aware, the firmware recovery process for travel routers is no different than the instructions found here: How to Use Firmware Recovery on a TP-Link Router
Are you able to start the process and see a webpage for the firmware?
There are a few older models that do not support the recovery process, so if you follow the instructions and everything fails, I would recommend reaching out to our official support channels for information on next steps.
- Copy Link
- Report Inappropriate Content
Thanks! Took me a while and several efforts at it, but I brought it back to life with the instructions you referred me to. Thanks!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 476
Replies: 2
Voters 0
No one has voted for it yet.