Deco M9 plus firmware update

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M9 plus firmware update

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco M9 plus firmware update
Deco M9 plus firmware update
2024-01-06 13:46:14
Model: Deco M9 Plus  
Hardware Version: V2
Firmware Version: 1.6.2

My original mesh network had three Deco M9 Plus nodes v2.8 with firmware version 1.6.2 

I just added another node which is the same hardware version, but the firmware is older 1.2.12.

In the app the new node is shown as a client to main node, not as a satellite node so I wanted to update the firmware hoping that would correct the configuration. When I try to update the firmware using app, it tells me that my current version 1.2.12 is up to date ???

I downloaded Deco M9 Plus Update Assistant on Windows laptop and manually upgraded to v1.6.2 but the new node still shows the old version 1.2.12.

 

Why this new node cannot be upgraded to version 1.6.2?

Why is it showing as a client to main node node not as a satellite?

 

Thank you for your help

Jack

  1      
  1      
#1
Options
2 Reply
Re:Deco M9 plus firmware update
2024-01-08 07:03:19 - last edited 2024-01-08 07:07:58

  @remiszj 

Hi, Have you tried to connect the laptop via an Ethernet cable to this 1.2.12 Deco, then run the update assistant again to see whether it could be updated to 1.6.2?

(it is also suggested to temporarily power off other 1.6.2 satellite Deco M9 plus during the firmware upgrade.)

Wait for your reply and best regards.

  0  
  0  
#2
Options
Re:Deco M9 plus firmware update
2024-01-08 10:34:51

Hi David,

I followed your suggestion and it worked!!

 

Thank you very much

Jack

  0  
  0  
#3
Options