Forums/
Deco
2024-06-17 02:22:10
I have my BE95 set up as an Access Point. When I insert SFP into my Netgear switch it is accessible via it's static IP 192.168.1.1. When I insert it into the BE95 it is not visible and not...
0HELPFULS
Forums/
Deco
2024-05-04 12:49:01
@yves_b the two Deco satellites are functioning as mesh nodes that is why they are disabling the Ethernet to prevent a loop.
0HELPFULS
Forums/
Deco
2024-05-04 12:47:22
@CDH70 Did you buy the "modem" or did it come with the service? All three connected to the same node means all three would be set as Access Points, not Mesh. The instructions note not to connect them...
0HELPFULS
Forums/
Deco
2024-05-03 11:49:56
Here's how I believe it should be wired: Fiber provides an ONT? Do you mind sharing which ISP? Did they provide you a router? ONTs are not routers unless you have service like AT&T which requires use...
0HELPFULS
Forums/
Deco
2024-05-03 11:41:19
@CDH70 In Access Point mode, the "main" Deco router will relinquish DHCP duties to a router ahead of it, but connected to the "modem/ONT". When you wire the other two Decos directly to the "modem"...
0HELPFULS
Forums/
Deco
2024-05-02 18:19:38
@CDH70 Google this support article please and hopefully the steps work: General Questions About the Ethernet Backhaul Feature on Deco Mesh Systems
0HELPFULS