ArcherC8LV5Offline
Following: 0Followers: 9
Forums/ Wi-Fi Routers
2021-10-20 23:20:46
Re:No WAN with new Router
The modem will sometimes not switch routers when a new one is installed. That is why you need to clear the modem’s memory so it will connect to the new one. I need to do that procedure when I change...
0HELPFULS
Forums/ Wi-Fi Routers
2021-10-20 18:19:48
Re:No WAN with new Router
@F1GT6 sounds like you are not getting the WAN. If it is zero, that is the issue. Most times you just power off and unplug the modem for five minutes to reset it. Power off router, then plug the...
1HELPFULS
Forums/ Wi-Fi Routers
2021-10-20 12:07:13
Re:AX6600/AX90 after firmware upgrade Honeywell T9 Thermostat won't see network
@lotharjk Since it is only one device that is having an issue, then I would suspect the device a bit more than the router. Since it worked before the firmware upgrade, I would check the WIFI settings...
1HELPFULS
Forums/ Wi-Fi Routers
2021-10-19 13:33:47
Re:Parental Control Archer C80
@zar903 If you cannot get the router controls to block those sites consider changing the DNS. Google 'dns that restricts adult content' for different options.
0HELPFULS
Forums/ Wi-Fi Routers
2021-10-16 12:43:33
Re:Does dns spoofing require communication to work and does ap isolation protect against dns spoofing?
@Johnsmith2 I am no great expert in DNS spoofing but do understand a few things. I would not think AP isolation would protect you. Generally, the DNS can be set at different places and depending on...
1HELPFULS
Forums/ Wi-Fi Routers
2021-10-16 00:25:24
Re:Router placement
@LFHoff per the install instructions, the router should be horizontal and the antennas vertical. See the second bullet point below the 1. Connect the hardware.
0HELPFULS
1120121122...