SOHO Switches
I have no issue connecting my devices to the Deco router, but the router will not connect to the internet. I have an Arris modem from RCN. I called RCN and they can see it's not connecting but they sa
0Helpful
52Views
I know that by default all networking devices have an ip of 192.168.1.1. My modem has been changed to another IP scheme. Now that I have connected the switch to my system, my PC Ipv4 is showing a 192
0Helpful
153Views
The typical home installation is to connect the customer WiFi router to the ISP modem and then connect EVERYTHING ELSE in the house to the customer WiFi router. This creates one "Layer 2" network. Whe
0Helpful
287Views
I have had issues with a vlan setup after adding a 3rd switch. I have a TL-SG1024DE switch that has vlans attached to it. Port 1 is connected to wifi router and untagged in all of the VLANs. Ports 2 a
0Helpful
166Views
Please help: I just tried to enter the device config and it does not work. I reset the device by pressing the back button and same thing. TL-SG108E came with a simple manual it says that config is at
By
WhatsAppJack
· Latest post 2025-03-06 16:38:05
by terziyski
0Helpful
271Views
I have 2 AX6000 routers that I want to use as 2 separate LANs sharing a single WAN connection. Connecting one to the other is not possible cable-wise, so they need to be in a Y configuration from the
0Helpful
195Views
I am getting ready to alter my current setup as follows: I have a home router that I will connect to a TL-SG105E switch on port 1. I will set up MTU VLANS using port 1 as the up-link port. As I unders
0Helpful
487Views
My switch is a TL-SG108E, which isn't listed here but also wasn't listed in the business section -- am I in the wrong forum? I noticed today that one of the green activity lights on my TL-SG108E switc
0Helpful
535Views
Good day, I just bought a TP-Link TL-SG108 SOHO switch. I'm not sure how "smart" this switch is or if there may be a better solution for what I'm trying to do. All of the devices that are connected to
0Helpful
490Views
I have (2) TP-Link switches in a flat network: A TL-SG108E and a TL-SG1016DE. When I run the Easy Smart Configuration Utility (v1.3.19.0) on my Windows 11 laptop, it cannot discover my two switches, h
By
Zeldar
0Helpful
616Views