HS220 as 3 way if only using one of the switches
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.HS220 as 3 way if only using one of the switches
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi there,
I am wondering if the HS220 will work in a 3 way swich if I only use that one switch with the HS220 installed to adjust the lights and not use the other switch at all?
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
You must replace the 3way that has the power connected.
Connect power to LINE of the HS220.
Connect both travellers to the LOAD of the HS220.
By connecting the HS220 this way the 3way switch that is at the other end can be toggeled without effecting the light.
Let us know how it goes.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Can you provide a little more info for this setup? I have 2 sets of can lights I am trying to put on a smart dimmer (HS220). Both of them are 3-way switches. If I leave the other switch alone, I just need to find the switch that has the POWER connected to it, correct? How do I identify that switch? How do you identify the travelers? Thanks!
- Copy Link
- Report Inappropriate Content
@OscarC You may want to use a electrician.
To identify the power source you will have the switches exposed and the power on. And use a meter or contactless tester.
- Copy Link
- Report Inappropriate Content
@B.Will I ended up just guessing and choosing the switch closest to the breaker box and luckily it was the right one! Only downside was I had to install it upside down as that was the only way it fit in my box. Also took some time for me to connect the 2 travellers and get them attached to the single screw as I'm no electrician. Glad it's working tho, thanks B Will
- Copy Link
- Report Inappropriate Content
@Jtmon3y Your Welcome, glad to be of help.
- Copy Link
- Report Inappropriate Content
@B.Will I have replaced multiple switches before. Just trying to figure out best way to identify the power switch. Once I take cover off and turn on power, will it be the one with the hot line?
- Copy Link
- Report Inappropriate Content
@OscarC The travellers are the brass/copper colored screws.
The common is the black screw.
Power on, light off, the common that has power is the hot(powered switch).
- Copy Link
- Report Inappropriate Content
@B.Will Thanks. I will give it a shot!
- Copy Link
- Report Inappropriate Content
@B.Will does anything connect to the neutral on the hs220? This is my setup now, I'll be replacing the left switch. : 
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 10427
Replies: 11
Voters 0
No one has voted for it yet.