After Calibrating- Lights won’t Dim

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

After Calibrating- Lights won’t Dim

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
After Calibrating- Lights won’t Dim
After Calibrating- Lights won’t Dim
2021-11-07 18:16:02
Model: HS220  
Hardware Version:
Firmware Version:

I installed the dimmer switch and tested before connecting and adding to the app. I could turn off and on the light and dim it.

 

I then added it to the app. When I got to the calibration part I lowered the brightness and lights were still on below the suggested setting but I put it at the suggested setting and moved forward in the setup. But... the lights weren't dimming when the switch or app was set to dim them.

  0      
  0      
#1
Options
1 Reply
Re:After Calibrating- Lights won’t Dim
2021-11-08 11:20:44

Hello @Al_Kasa 

We have a guide here that might be able to help with your concern, you could try Calibration again, and also check the type of dimming of your bulb: 

What should I do if the HS220 cannot dim the light properly?

Can I know the model of your dimmable bulb, its power consumption, it is better if you could help attach a link of the bulb, thank you. 

  0  
  0  
#2
Options