Automation: When H100#1 rings, Then cause H100#2 to ring
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Automation: When H100#1 rings, Then cause H100#2 to ring
I have two H100 hubs, one has two T100 motion sensors and the other has one T100.
I can set up Automation to have a motion sensor event cause its respective hub to ring with a unique tone; no problem.
What I want is for a motion event with hub#1 to cause the hub#2 to ring. Seems easy with Automation but it doesn't work.
When Trigger = Hub#1 status = ring
Then Action = Hub#2 status = ring
When I trigger the motion sensor for Hub#1 I hear it's unique chime but I don't get anything from Hub#2 in response.
(updated firmware, no wifi partitions, all devices in same room for now, .....).
Please tell me I'm missing something obvious!
Thanks,N