Forums/
Range Extenders
2021-03-01 23:27:59
@Brynlee The extender is mainly meant to connect to an existing wireless router, then extend the signal further. After the extender is set up you can then connect an Ethernet cable to the device to...
0HELPFULS
Forums/
Wi-Fi Routers
2021-03-01 23:24:13
@Nightmare The first thing I would check is the IP addresses to make sure there is no conflict that can kill any communication. The AX1500's LAN will be 192.168.0.x, but if it gets an IP on the WAN...
0HELPFULS
Forums/
Range Extenders
2021-03-01 23:13:36
@jeff.freedman The extender will copy the settings of the router so if you need 20 MHz for your 2.4G, set that in your router. If you have a TP-Link router the option to change the width may not be...
0HELPFULS
Forums/
Wi-Fi Routers
2021-03-01 23:08:32
@ZizoMass I don't see anything eluding to tapping into another router that has the USB-connected printer. Does the printer have an Ethernet cable that you can connect to the router instead?
0HELPFULS
Forums/
Deco
2021-03-01 23:04:12
@RobAuerNJ If the Deco unit reset is held for an extended period of time it will place it in recovery mode. You could try to leave it powered on for several minutes, and then when doing the reset,...
0HELPFULS
Forums/
Wi-Fi Routers
2021-03-01 23:02:26
@Volvstang If nothing changed on the router end, then something changed on the opposite end. Go to Advanced > NAT Forwarding > ALG, and make sure PPTP passthrough is enabled. If that still does not...
1HELPFULS