WiFi
TP-Link Omada EAP Series contains Ceiling Mount AP, Outdoor AP and Wall Plate AP, providing centrally manageable and secure business-class wireless network solutions. Anything related to TP-Link's Omada EAP series products, welcome to ask questions, join discussions and share your experience/knowledge here.
WiFi
Hello, I have 4 EAP's and I was looking to bind some clients to a single one for certain reasons. My only solution was to try and create a WLAN from that single EAP, however since all the EAP's are in
MeshRoaming
3Helpful
171Views
Hello, I need some advice. I need to use MESH technology on AP EAP650-Wall(EU) v1.0 - But I don't have the option to turn it on anywhere. EAP650 on the ceiling normally supports MESH, but not WALL. Ca
MeshInstallationEAP650-Wall
By
Stan77_JMNET
· Latest post 2023-12-31 21:35:06
by d0ugmac1
1Helpful
350Views
Hello! I have installed an EAP653 as AP for my Fritz!Box 5530 YW as the main router via a LAN cable from the basement to the 2nd floor. I just took all pre-configured settings and managed to establish
MeshNetwork ConnectivityInstallation
0Helpful
217Views
Hello everyone this is my setup below ER605 -> OC200 -> SG2210P -> EAP610(ROOTAP) ----wirelessbackhaul---> EAP610 (CHILD AP) ---wired thru eth port of CHILD AP---> pc ---- other wireless connection --
VLAN & Multi-NetworksMeshNetwork Connectivity
0Helpful
236Views
Hello, I am dealt with WIFI in a while, I am helping a friend set up APs for a small resort in Bora Bora. The guest bungalows WIFI was previously handled by an older Ubiquity Loco M2 which performed p
Network ConnectivityWi-Fi 6EAI WLAN OptimizationMesh
By
OAOA-bora1
· Latest post 2023-12-28 02:39:58
by OAOA-bora1
4Helpful
414Views
Hello everyone. I have an omada stack ER605 -> TL-SG2210P -> EAP610 (PARENT) ---> EAP610 (CHILED Meshed) -> OC200 I've been configuring a Guest VLAN with a subnet of 192.168.250.1/24 and a IoT VLAN wi
VLAN & Multi-NetworksNetwork ConnectivityMeshACL
0Helpful
263Views
the device doesn't appear in my omada sdn software controller. It appears when i am using the omada app on my tablet. How can i adopt it on my controller if it doesn't appear? i tried resetting but st
MeshInstallation
0Helpful
182Views
Hi @alI. installed the Omada controller on the Synology a few weeks ago. I have transferred (adopted) my 3 access points to the controller and everything is going very well so far. Yesterday I wanted
Network ConnectivityInstallationVLAN & Multi-NetworksMesh
0Helpful
317Views
So i have recently connected a new secondary router to act as a backup in our office network, however when i did so, one of our APs disconnected and restarted itself, now outright refusing to use its
MeshInstallationWired Uplink Error
By
ATC23-IT-PH
· Latest post 2023-12-23 03:13:41
by KJK
1Helpful
572Views
Hello everyone, i can't explain very much what i intended to do. However, i just wanted to know if a OMADA meshed EAP (any compatible model) supply the connection whiles being powered by a POE switch.
MeshInstallationRoamingEAP
1Helpful
385Views