Camera is not resetting
The camera suddenly stopped working. I have tried numerous times to reset it, but it doenot. What to do so that it starts working again.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
You can try the following steps and see if they help.
1. Turn off your camera, and remove the SD card from it if there is one. Turn the camera back on with the original power adapter and cord.
2. Wait for two minutes, press and hold the reset button on the camera for 10 seconds to perform a factory reset. Then, check the LED status on the camera.
3. If the LED is flashing red and green, you can try to reconfigure the camera in the Tapo app: How to set up the Tapo camera
4. If the camera's LED does not change and the camera does not respond to the reset operation, you can contact your retailer or the local support team to check if the camera is under warranty.
Best Regards
- Copy Link
- Report Inappropriate Content
Hi,
You can try the following steps and see if they help.
1. Turn off your camera, and remove the SD card from it if there is one. Turn the camera back on with the original power adapter and cord.
2. Wait for two minutes, press and hold the reset button on the camera for 10 seconds to perform a factory reset. Then, check the LED status on the camera.
3. If the LED is flashing red and green, you can try to reconfigure the camera in the Tapo app: How to set up the Tapo camera
4. If the camera's LED does not change and the camera does not respond to the reset operation, you can contact your retailer or the local support team to check if the camera is under warranty.
Best Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 129
Replies: 1
Voters 0
No one has voted for it yet.