I am getting the 3 pack of Deco X50 Pro because they have the 2.5Gb ports and we pay for 1.5Gb speeds to our house. However my ISP provided modem/router only has 4 1Gb ports and a single 10Gb port. I

I am setting up a mesh network having recently installed full fibre broad band. I am with Vodafone (Ireland) and use a Gigabox modem router. My current WiFi set up is with 10-year-old old TP Link 10/1

Network map: archer c6 (router) (second floor 1st bedroom) -> deco x60 (second floor 2nd bedroom) | deco x60 (main) (living room) (first floor) All are connected via ethernet backhaul wired by using c

Hi, I am currently using a VX230v as the modem router. It works fine and is connected to the internet. Its EasyMesh is enabled. I want to use this as the EasyMesh Controller and connect it to a range

I have a Deco M5 (set of 3) I'm connected to Australia NBN via Optus on a 50 Mbps plan Deco #1 is connected via Access Point to my Optus Router/Modem My Optus Router/Modem is connected to the NBN Conn

Hi everybody, I had a completely wireless setup using two decos, but I've had intermittent problems with them losing connection to eachothers so I built an ethernet backhaul. Everything has been worki