Hi, I bought a 4x4 access point so i could use it with more than one 2x2 client at a time. One client (Intel AX200) gets a maximum of 800 Mbit/s. That's good. However, when I use two clients at a time

Team, See also attached image: We just finished a vulnerability scan against our TL-ER7206 v1.0 (firmware 1.2). There are 2 issues that would prevent us from onboarding a (potential) customer because

Hi all, sorry for this long message :-) I have been able to setup either L2TP or Openvpn client to LAN access to my home network, but I am still not able to setup an Ipsec IKev2 policy for client to L

Good morning, I was looking through my logs and I've found a strange entry in the routing table: The IP-address belongs to a school community in Tampa, Florida while I am in the Netherlands. I don't r

Dear all, looked for a midrange priced Controller Based WLAN Solution and installed the software based Controller Version on Debian 11 in an VMware 6.7 enviroment. I did a lot of reasearch for my Scen

I recently purchased an ER605 router, an SG2008P switch, and a few EAP660's for a small deployment as a first time TP-Link Business customer. My intention was to use the Software Controller from a sma