Archer VR400 user interface issue with "IPv6 Tunnel" settings page

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer VR400 user interface issue with "IPv6 Tunnel" settings page

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

__gianni

2019-05-14 13:05:12 - last edited 2019-05-15 06:32:25

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2019-05-14

Archer VR400 user interface issue with "IPv6 Tunnel" settings page

2019-05-14 13:05:12 - last edited 2019-05-15 06:32:25

Model: Archer VR400

Hardware Version: V1

Firmware Version: 0.2.0 0.9.1 v0070.0 Build 170302 Rel.50751n

Hello,

I am trying to set up a 6rd IPv6 Tunnel to get ipv6 to work between my LAN and my ISP.

Unfortunately while configuring the required settings, I am encountering this issue where as I try to save the configuration, when the page refreshes the "Enable" checkbox gets unticked, although I had it ticked before.

This happens without any error notifications of any kind (and I experienced some error notifications during configuration, so there is some error checking), it just unticks.

Screenshot of the page before pressing "Save":

Screenshot of the page after pressing "Save":

I'd like to make ipv6 work but I am stuck here since it silently fails.

Any help would be apreciated, thanks.

1 Reply

Kevin_Z

2019-05-20 07:33:04

Posts: 21782

Helpful: 5161

Solutions: 2575

Stories: 21

Registered: 2018-12-24

Re:Archer VR400 user interface issue with "IPv6 Tunnel" settings page

2019-05-20 07:33:04

Hi,

Our engineer will contact you via email, if you are willing to do further troubleshooting, please notice your inbox.

Have a good day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Archer VR400 user interface issue with "IPv6 Tunnel" settings page

Archer VR400 user interface issue with "IPv6 Tunnel" settings page

Information

Voters 0

Tags