Cant configure Tapo C200 Camera
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
Need assistance on my Tapo C200 Camera. I can't do the configuration. Steady RED Light only. Can't reset also
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello @Oizned
Please try to factory reset tapo camera again device powered on please heck if camera still responds to a factory reset , or if the camera still broadcasts the Tapo Camera _XXX default SSID, or if the LED flashes amber and green?
If the camera still has a solid red and does not flash amber and green, it could be some issue with the camera, may I know was there any firmware update failure, or power outage before this happen? You could contact retailer or local support to check device warranty.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
In my experience when your reset the camera (with the power on it gives a little beep when done then you unpluag ,wat 10s and power up then it shoudl go through its start upo cycle and eventually it shoud end up with a flashing red/green - meaning its ready to pair
if you dont het this far the devide must be faulty IMHO
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 864
Replies: 3
Voters 0
No one has voted for it yet.