Deco S4 wireless clients appear as wired

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco S4 wireless clients appear as wired

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco S4 wireless clients appear as wired
Deco S4 wireless clients appear as wired
2022-11-21 06:21:18
Model: Deco S4  
Hardware Version:
Firmware Version: 1.5.1 Build 20220113 Rel. 42007

Hi there, 

 

I have 3 Deco S4 units, where the main is in router mode, the second (connected via ethernet back haul) is in AP mode and the third, connected to the second deco via ethernet back haul is also in AP mode.

Wireless clients connected to the main and second Deco behave as expected, I can enable/disable mesh per device and I can see which client is on which Deco. 

However, for the third Deco (connected in daisy chain to the second, which is in-turn connected to the main) all clients show up as wired on the app and I have no means of managing them

I'd like to know if there's any reason that wireless clients show up as wired on the third deco and if anything can be done to remedy this?

Thanks, 

Mike

  3      
  3      
#1
Options
1 Reply
Re:Deco S4 wireless clients appear as wired
2022-11-22 03:10:57

  @mikesoper Hi, welcome to the community.

Do you use Deco APP 2.0 or 3.0?

If you are still on 3.0, please refer to this link and install Deco APP 3.0 to see whether the issue could be fixed.

https://community.tp-link.com/en/home/forum/topic/581574

If not, could you please help me submit the APP log per the link:

https://community.tp-link.com/en/home/forum/topic/581574?replyId=1132466

Thank you very much.

Best regards.

  0  
  0  
#2
Options