Beta Software Deco M4/S4_V2 Support Connection Preference
This Article applied to
Deco M4_V2_1.5.8
Deco S4_V2_1.5.1
Download Link:
| Deco M4_V2 | Deco M4_V2_1.7.0 ( New version updated on 2024.3.7) |
| Deco S4_V2 | Deco S4_V2_1.6.1_build_20240328 (updated on 2024.4.19) |
1. Please be sure you have read the Terms and Conditions for TP-Link Beta Firmware before proceeding.
2. For Deco M4_V2, the firmware downgrade(back to the official 1.5.8 version) needs to be implemented via firmware recovery.
3. For Deco S4_V2, it would revert to the official 1.5.1 directly via web UI.
4. How to update the firmware via web UI.
Firmware Modifications:
| Deco M4_V2_1.7.0 |
|
| Deco S4_V2_1.5.1 |
|
Please feel free to comment below if you have any issues with these two firmware versions!
Related Articles:
Connection Preference: Customize Your Preferred Signal Source
Understand the Differences Among Deco Firmware Platforms
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@David-TP 2.4ghz slow worked & static routing not worked otherwise is good can you release stable version.
- Copy Link
- Report Inappropriate Content
Compliments to TP-Link. Finaly solved my issue. Now i can master how my satellite Deco makes contact with.
Hopefully soon this will the release for more users. It's worth it.
Thanks for the quality of the product.
Ps. I have also a X10, hopefully the firmware will give the system the opportunity to do the same..
Greetz
- Copy Link
- Report Inappropriate Content
ARGamingPK1 wrote
@David-TP Why there is no more IGMP option after updated to 1.7.0 on Deco M4?
@ARGamingPK1 It's not there on version 1.6.1 as well
- Copy Link
- Report Inappropriate Content
Hi, Thank you very much for your time and patience.
Is there any chance that you could start a new thread here to explain what you'd like to achieve via static routing and how it has been configured on the Deco M4?
Wait for your reply and best regards.
- Copy Link
- Report Inappropriate Content
Have your engineers figured out what's the problem when the M4 is set up as access point?
Edit: i'm referring to the red flashing when they're working in AP mode.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@David-TP Everything is working good with 1.7 firmware (I have 5 x M4 and the main one is set as router mode).
I have now the possibility of replacing 3 of them (main one which acts as router and other two of them) with 3 x Deco X50.
Does Deco X50 allows for source selection? Will a mix of 3 X50s and 2 M4s work right and will allow for manual sporce selection? Will I gain some benefits or it is a waste of time? I could buy them for office but I don't really need the extra "gain" of X50, so I could replace them with 3 x M4s which I'm currently using at home.
Thank You for Your help
- Copy Link
- Report Inappropriate Content
@David-TP Any ETA of official stable release?
- Copy Link
- Report Inappropriate Content
@David-TP what is problem at 2.4ghz signal strength -45 db excellent but connection speed is 6mbps why.......????
- Copy Link
- Report Inappropriate Content
Information
Helpful: 6
Views: 41161
Replies: 236
Voters 3
