Beta Software Deco M4/S4_V2 Support Connection Preference
This Article applied to
Deco M4_V2_1.5.8
Deco S4_V2_1.5.1
Download Link:
| Deco M4_V2 | Deco M4_V2_1.7.0 ( New version updated on 2024.3.7) |
| Deco S4_V2 | Deco S4_V2_1.6.1_build_20240328 (updated on 2024.4.19) |
1. Please be sure you have read the Terms and Conditions for TP-Link Beta Firmware before proceeding.
2. For Deco M4_V2, the firmware downgrade(back to the official 1.5.8 version) needs to be implemented via firmware recovery.
3. For Deco S4_V2, it would revert to the official 1.5.1 directly via web UI.
4. How to update the firmware via web UI.
Firmware Modifications:
| Deco M4_V2_1.7.0 |
|
| Deco S4_V2_1.5.1 |
|
Please feel free to comment below if you have any issues with these two firmware versions!
Related Articles:
Connection Preference: Customize Your Preferred Signal Source
Understand the Differences Among Deco Firmware Platforms
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Lalolelendo ah....! Beta version
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, I'm afraid the 1.7.0 beta is for Deco M4_V2 only. Best regards.
- Copy Link
- Report Inappropriate Content
@David-TP thank you for your response. In my house i have a mesh network from two V2's and two V3's M4R Deco. If i install the beta firmware to the V2's , the connection preference will be available to all of my Deco units?
- Copy Link
- Report Inappropriate Content
Is there any eta on when tis feature will be added to the normal firmware and no longer be in beta?
Because if this is added to the normal update stream then i can be sure that it qill not cause any issues with bugging out and can safely buy another m4 to finally replace the last deco in my mesh that doesn't support this feature
- Copy Link
- Report Inappropriate Content
Information
Helpful: 6
Views: 41306
Replies: 236
Voters 3
