BE63 no internet on guest network ethernet backhaul
So I just upgraded from the older XE75 mesh router system to the new BE63. In trying to keep all my old settings i plugged in the new unit add chose to add to my then current setup. After adding to the old mesh system i then chose to set the new unit as my main router before adding the remaining 2 units. I thought everything was fine until i realized the guest network is not getting internet. The units are connected with ethernet backhaul and no switch in between. They are being used in router mode as well so no isolation option causing issues. I have installed the latest firmware on all the units and tried to reboot them with no luck. Any help is appreciated.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, welcome to the community.
It is suggested to install the 1.1.0 firmware here and it should fix this issue now.
Deco BE65_V2_1.1.0 Supports WireGuard VPN, Channel Selection and More
Wait for your reply and best regards.
- Copy Link
- Report Inappropriate Content
Hi, Is it only the Guest network from satellite Deco units? can you connect to the Guest network of the main Deco BE63 and access the internet?
-If it is just the satellite Deco, I've sent a beta firmware in the Message and please check whether it helps fix the current issue.
Wait for your reply and best regards.
- Copy Link
- Report Inappropriate Content
New firmware seems to have fixed the isssue! Yes it was only the satellite decos that did not have internet on the guest network. Thank you very much!
- Copy Link
- Report Inappropriate Content
@David-TP Hello! I have the same problem. My Guest network doesn't have internet. I have tried direct connection between Mesh routers and via the switch (I use an ethernet cable to connect them) - but nothing helps. Can you please send me this beta version of the firmware? I also use BE63 mesh system. Thank you!
- Copy Link
- Report Inappropriate Content
@David-TP Hello! I have the same issue with the same setup. Is there an ETA on when the beta firmware will be released? Can you send me the updated firmware as well? Thanks!
- Copy Link
- Report Inappropriate Content
Hi, welcome to the community.
It is suggested to install the 1.1.0 firmware here and it should fix this issue now.
Deco BE65_V2_1.1.0 Supports WireGuard VPN, Channel Selection and More
Wait for your reply and best regards.
- Copy Link
- Report Inappropriate Content
@David-TP The update solved my problem! Thanks for your help!!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 405
Replies: 6