X20 Deco Ethernet backhaul looping
Greetings
I recently bought cat 8 ethernet cables to upgrade speeds from my X20 Mesh,
my first configuration is as follows:
ISP Router >> Main Deco >> (Ethernet) Satellite 1, and the satelite 2 via WiFi,
This configuration seems to work perfectly but when doing this config:
ISP Router >> Main Deco >> (Ethernet) Satellite 1 >> (Ethernet) Satellite 2
Satellite 1 & 2 seem to go into a loop and then go to blinking red lights.
im following this instruccions:
What am I doing wron as soon as i connect port 2 to port 1 from satellite 1 to satellite 2 they go in loop
Please assist
Hello
Than you for our response, m topology is exactly as stated:
Juste checked the cable with other different devices and works perfectly seems to be a problem of communication within the satellites
i appreciate an advise
regards
When connected to all ethernet everthing goes wonky, devices beggin to dissconnect even shows my mobile wired
See main bedroom and living room showing 0 connected and the main (Office) shows 23 i have aprox 30 devices connected on a regular basis
This set up works prefect:
