Patrol mode not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Patrol mode not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Akbarpasha123

2025-05-28 06:47:37 - last edited 2025-06-12 03:21:23

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2025-05-28

Patrol mode not working

2025-05-28 06:47:37 - last edited 2025-06-12 03:21:23

Tags: #Recording

Model: Tapo C220

Hardware Version: V1

Firmware Version: 1.2.5

After I am set 3 view point in patrol mode

Camera is set at only 1 st view point at 2 minutes stay only, but camera not go to automatically to 2 and 3 view point after 2 minutes after 10 hour my observation only one view point showing

1 Accepted Solution

Solla-topee

2025-05-29 09:24:58 - last edited 2025-06-12 03:21:23

Posts: 18421

Helpful: 3148

Solutions: 4032

Stories: 11

Registered: 2020-05-19

Re:Patrol mode not working -Solution

2025-05-29 09:24:58 - last edited 2025-06-12 03:21:23

@Akbarpasha123

Hi,
If the Patrol mode is not working, please refer to the following steps to troubleshoot:
1) Go to the camera's Live View page to check if the prompt "Patrol Mode is on" appears. If not, go to the camera's Device Settings > Pan & Tilt > Patrol Mode page to ensure the Patrol Mode is turned on.
2) Please go to the camera's Device Settings > Pan & Tilt > Patrol Mode > Patrol Mode Schedule page to check whether the Patrol Mode is currently in effect.
Best Regards

>> Smart Home: Introduction to Common Smart Action Scenarios for Tapo Cameras >> Tapo Camera Day/Night Mode Selection Guide: Best Settings Recommendations for Different Scenarios >> What should I do if my Tapo camera triggers false detection? >> Enhance Your Tapo App Experience: Introduction to Several Practical Features

Patrol mode not working

Patrol mode not working

Information

Voters 0

Tags