BE65 V2

Update firmware to this new one somehow fix my issue on this thread.

https://community.tp-link.com/en/home/threads/topic/852972

Now I can hit around 300 mbps with my phone but still not the same speed when using x50 as main tho. WiFi feel speed also feel a bit more stable as well compared to 1.2.0 firmware.

BE65EU V2

I just installed this on two BE65EU V2 units, and everything seems to be running smoothly so far.  
 

I didn't encounter any of the the issues reported by @navzptc. 🤷🏻‍♂️

I have my main Deco connected to my ONT using PPPoE and my second Deco is connected via Ethernet and used to extend coverage. 

  @David-TP will trying this beta impact my warranty in any way?

@LowPing23 read the Beta Test Agreement. The answer to your question is covered there. 

I have updated my one BE65 V2 (I also have a V1 in a different area) I will monitor for issues and report back if I notice any problems.  So far all is stable and working well.

  @David-TP 
 

TP-Link = Regret..."

"While I can see maximum speeds (D 990mbps / U 980mbps) through the Deco App's internal speed tests on my TP-Link Deco BE65v2, the WiFi upload speeds (D 923mbps (OK) / U 320mbps(Not OK)) never reach their full potential, even from just 10 cm away. It behaves as if there’s a hard speed limit. Occasionally it stabilizes and hits max speeds, but then it starts acting up again—it's driving me crazy. The beta firmware reduced the disconnections, but the performance is still abysmal.
 

Other Settings :

Mesh on ethernet 
MLO is Off
Active chanelle 5&6Ghz  / Inactive 2.4Ghz

QOS is Off

Priority : There is no prioritization for any device.

Tester devices Samsung s25 Ultra + Ipad Pro M5

  @aykuttasdelen 

Hello.

I have a 2,5 gbit / 500. Internal test is ok, but speed tests show problem in upload. it's a problem, in my case, related to communication between ont and router generating bufferbloat problem. I solved partially enabling QoS. Now upload speed is ok, but download is a little bit capped.

Bye  

  @David-TP 

I have had terrible luck with this update. I updated my BE65-outdoor unit to this firmware version and its basically a brick now. It will no longer connect via wired backhaul and instead uses wireless backhaul. When you get out of range of the other decos it now doesn't broadcast any SSIDs from the unit itself. I have factory reset and readded the unit atleast 10 times and the issues still remain. I have cameras that are only in range of this unit and they no longer connect. When you try to pair the cameras if says no wifi connection found. Prior to the update all devices connected just fine. I have tried phones and laptops and all act the same. I really wish there was a way to revert back to the previous firmware.

  @bramezan 

If you can still connect to the device wirelessly, you need to open the web interface on your computer and install this update via the relevant deco interface. (Install the firmware compatible with your device version)

  @aykuttasdelen 

I have tried multiple times but it fails. It gives the message below.....

"Upgrade failed. Please select the latest version of firmware to upgrade."

I am currently on 1.2.10 and I'm pretty sure support told me you can go backwards with the firmware on the decos.

On my original post i said it would only connect via wireless back haul but i think the app is just showing that. If i disconnect it from the switch it goes offline. I even tried plugging a network cable into the 2nd port of the outdoor unit and there is no connection so I think both the wireless and wired ports are not functioning.