Missing EasyMesh Client Binding option on AX80 + 2x AX55 sattelite
Hello,
I’m using an Archer AX80V V1 (EU) as the main router with two Archer AX55v1 units as EasyMesh satellites.
I’m trying to use Client Binding to Preferred Mesh Node, but this option is currently missing.
I believe this option may have been available around a year ago, possibly when I was using beta firmware, but I’m not completely sure whether it was supported directly by the AX80V1 at that time.
What I do know is that the Archer AX55 supports Client Binding, so I expected this option to also be available when the AX55 units are used as EasyMesh satellites.
My current versions are:
- Archer AX80V V1 (EU) - firmware 1.4.1 Build 20251117 rel.76722
- Archer AX55 - firmware 1.5.12 Build 20260521 rel.72016
The EasyMesh network itself works correctly, but I cannot manually bind a client device to a specific AX55 satellite.
Could you please confirm:
-
Should Client Binding be available in this AX80V1 + AX55v1 EasyMesh configuration?
-
Is this feature controlled by the main router firmware, even when the AX55 satellites support it?
-
Was Client Binding available in any previous or beta firmware for the AX80V V1 (EU)?
-
Is there any plan to add or restore this feature?
I’d also like to ask whether TP-Link plans to add the following features to the Archer AX80 V1 (EU) in future firmware updates:
- EasyMesh R3 protocol / Extended Mesh features
- VPN Merge
Are any of these features planned for the AX80V V1 (EU)?
Thanks!
