W38122077 wrote Clive_A wrote Hi @W38122077 Thanks for posting in our business forum. W38122077 wrote @Clive_A Is there a guide for how to properly do the "Disable NAT" feature when being used with a...

@djwujek I don't know why it won't start, there could be a lot of things causing problems but as you can see, Omada needs 1.2 GB of RAM to start and it increases gradually so until you solve the RAM...

@djwujek I did a test here on a 2GB Raspberry Pi4 with Raspberry Pi OS, once everything is installed it uses 1.2GB (but it will probably increase). If you create a larger swap file then you might be...

@djwujek It's not strange at all. You can run Omada on almost any hardware but you need to have 2gb I recommend 4gb as a minimum, the number of cores on the processor doesn't matter so much in small...

@Clive_A To downgrade the firmware, you need to log in to the router's console using SSH, then type these commands. enable (Turn on privileged commands) roll-back (Roll back to the previous software...

Clive_A wrote Hi @MR.S MR.S wrote @GRL It's SD-WAN that I've been looking forward to the most, so hopefully it will come to the other routers in beta soon. Too bad you had problems with your upgrade,...