@Tobias8250 You cannot change the default profile. you must create a new profile with the desired settings, then you must assign this profile to the switch port.

@MTHAREJA then I don't know, if the controller is on the same network as the access points, they should appear in the console. are you sure that the access points have not been adopted into another...

@Geert_V There is a solution but it is not very good, if you have an Omada switch you can do some LAN to LAN ACL on the switch. Omada is a network for the SMB market, I would almost say SOHO/SMB, so...

@MTHAREJA go to global view, then Controller Settings, make sure that Show Pending Devices is enabled.

@MTHAREJA Which hardware version and which firmware version do you have on the access points? And do you have access to AP web console in stand alone mode?

@MrHC1983 2.5G WAN1 is WAN only and cannot be changed. this is the default WAN for this device. that's probably why the port is called 2.5G WAN1 and not 2.5G WAN/LAN1 Why?? I do not know.. But that...