plugged my new m5 mesh system into existing zyxcel router. all works well except devices keep reverting to the zyxcel network and i have to manually switch them back to m5

When I set each one up, I had to say what room it was in. The house has a complicated layout, so one Deco might be actually be within range of two or more of its "siblings", and able, theoretically, t

According to the link below, you should be able to click on the Internet icon, then click on one of the satellite Deco, and you will see the satellite Deco’s signal source is wifi or ethernet. However

I understood from a TP-Link instruction page that when using more Deco units throug ethernet, the 2nd, 3rd, etc units need to be daisy chained to the 1st or need to be connected through star topology,

We have a very thick (1+ meter) wall in the centre of the house that wifi does not go through well. We have seperate ring mains either side of the wall so can't use powerline to get around it either.

My current setup for 2 decos as follows: Secondary Deco M9 plus connect to TPlink SG105 (SWITCH) by CAT6 ethernet cable. The switch is connecting directly to the main Deco M9 plus. I placed the second