Home

Forums

Stories

Knowledge Base

Smart Home Community > Kasa Smart Switches > Smart switch stoped working after year and new switch doesn’t work either

< Kasa Smart Switches

Smart switch stoped working after year and new switch doesn’t work either

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Smart switch stoped working after year and new switch doesn’t work either

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Trev

2018-12-23 00:42:27

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2018-12-23

Smart switch stoped working after year and new switch doesn’t work either

2018-12-23 00:42:27

SmartSwitch stopped working after about one year. Smart switch is in a three gang box with two other non-smart switches. the smart switch shows a connection and lights up but for some reason it does not turn the lights connected to the smart switch on. I think maybe I should replace the nonsmart switches in the same gang box. Any thoughts?

2 Reply

Kevin_Z

2018-12-25 08:07:39

Posts: 21624

Helpful: 5062

Solutions: 2550

Stories: 21

Registered: 2018-12-24

Re:Smart switch stoped working after year and new switch doesn’t work either

2018-12-25 08:07:39

Hi Trev,

If you cannot control the lights by the smart switch, please check if you are on the latest firmware,

if it's not latest , please upgrade the firmware , about how to upgrade the firmware, you can click on the following link to get some help:

https://www.tp-link.com/us/faq-2325.html

And you mentioned ,you have a new switch, if you use the new switch, to take place the old one, it doens't work either?

Yes, you can try to use the normal switch and test if it can work fine.

Merry Christmas.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

MikeP

LV2

2018-12-25 18:41:22

Posts: 284

Helpful: 127

Solutions: 10

Stories: 0

Registered: 2018-10-05

Re:Re:Smart switch stoped working after year and new switch doesn’t work either

2018-12-25 18:41:22

if by "replace the nonsmart switches" you mean change those to smart switches that will have no effect. If you replaced the old switch there's a small chance the new one is broken too, but more likely the wiring isn't correct. Double check that all of the wires are touching and tight in their connectors, and that you swapped the right ones over. You're sure the old switch was broken, it's not the fixture that failed? Was it still clicking when activated?

AutomationManager: Secure home automation without relying on cloud servers.

Smart switch stoped working after year and new switch doesn’t work either

Smart switch stoped working after year and new switch doesn’t work either

Information

Voters 0

Tags