4 cameras not acquiring dhcp reservation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

4 cameras not acquiring dhcp reservation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
4 cameras not acquiring dhcp reservation
4 cameras not acquiring dhcp reservation
2022-09-21 10:31:54 - last edited 2022-12-12 20:14:04

2 - C310

2 - C200

 

Using Omada SDN controller to assign IP reservations to all 3 cameras. After reboot of all 3 cameras, they do not get assigned the reserved IPs I set for them. They automatically acquire an IP from  the DHCP pool. I have 6 other Tuya IoT devices that have reserved IPs with no issues after device recycle. These cameras have to be rebooted every 24hrs to reduce lag and crashes when viewing. But these cameras refuse to accept the IPs that are reserved for them! This makes it especially annoying because I would have to change the cameras' IP addresses in OBS and the VIGI NVR every time the IPs change!

 

Why is this happening?

What is the fix?

Why aren't support adn devs replying to other posts about this issue?

Is there a dev firmware that may fix this issue?

 

thanks

  3      
  3      
#1
Options
1 Accepted Solution
Re:4 cameras not acquiring dhcp reservation-Solution
2022-12-12 19:55:39 - last edited 2022-12-12 20:14:04

  @Solla-topee 

 

there was/is an issue with the Omada ER605 router this is the fix until an official firmware is released

 

https://community.tp-link.com/en/business/forum/topic/542294?page=1

Recommended Solution
  3  
  3  
#3
Options
3 Reply
Re:4 cameras not acquiring dhcp reservation
2022-10-14 08:21:56 - last edited 2022-10-14 08:47:40

 Hello  @NoMadPH 

Sorry for the late reply,

Double check if there is any Wi-Fi extender between router & the camera,

To help isolate the issue, try to connect the camera directly to router if possible, not AP or extender and see if that makes any difference. 

 

For ' they do not get assigned the reserved IPs I set for them. They automatically acquire an IP from the DHCP pool.' 

Can you help provide some information 

 

1) a photo of the IP reservation settings &  IP address did not accord to the IP reservation settings. 

2) the MAC address of the camera (please share via PM)

3) Model of the router, and network topology ( note if have any Wifi extender in the network topology) 

Example: ISP X - router Archer C7  -<Ethernet> AP model <Wireless>Tapo C100

 

 

 Thank you. 

  0  
  0  
#2
Options
Re:4 cameras not acquiring dhcp reservation-Solution
2022-12-12 19:55:39 - last edited 2022-12-12 20:14:04

  @Solla-topee 

 

there was/is an issue with the Omada ER605 router this is the fix until an official firmware is released

 

https://community.tp-link.com/en/business/forum/topic/542294?page=1

Recommended Solution
  3  
  3  
#3
Options
Re:4 cameras not acquiring dhcp reservation
2022-12-13 00:49:16

  @NoMadPH 

Glad to know the issue is solved on the router side! Thank you very much for sharing the solution with the community.  yeslaugh

  0  
  0  
#4
Options