Tapo D230S1 setup issue
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I'm unable to connect my new D230 doorbell to the supplied hub (H200). I have tried two different networks, ethernet and wi-fi connections, android and iOS apps. The apps see both the hub and doorbell camera correctly but will not 'pair' the two together, telling me to check the status lights, move them closer together, and consider resetting them, all of which I have tried a number of times. The H200 seems to setup correctly as a device and I can interact with it but I cannot connect the doorbell to it. Please help.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
Before installing the Tapo D230, please help check if the H200 is connected to the internet.
1. What's the LED status on the H200 when it connects to the router via Wi-Fi or ethernet cable?
2. Do you have internet when connecting to the router's Wi-Fi or via a cable?
3. Is your network diagram the Internet--wireless router--H200?
4. Can you control the H200 when turning off the Wi-Fi on your phone and using the mobile data?
Best Regards
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi,
1. If you have two hubs, please turn off the one you don't need to connect to the camera and move the other one close to the camera.
2. Reset the camera Tapo D230, and wait for a while until it has a flashing red and green light
3. Reconfigure the camera and check if it will work fine.
How to Set Up Your Tapo Video Doorbell Camera Kit (Tapo D230S1)
Best Regards
- Copy Link
- Report Inappropriate Content
@petunia2t hi, I'm just curious if you got a solution, as I am having the same problem.
thanks
- Copy Link
- Report Inappropriate Content
Hi,
You can refer to the instructions below to troubleshoot your case.
What can I do if the battery-powered cameras fail to pair with the Tapo H200?
Please help confirm the following information if the problem remains.
1. A picture of the error message appears on the Tapo app when configuring the camera.
2. The LED status on the Tapo H200 and the camera when you see the error message.
3. Did the camera work before?
4. Is your network diagram the Internet--wireless router--H200? Please describe your network diagram in detail.
Best Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2579
Replies: 5
Voters 0
No one has voted for it yet.