Motion detection nit working as expected, annoying

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Motion detection nit working as expected, annoying

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Motion detection nit working as expected, annoying
Motion detection nit working as expected, annoying
2023-11-21 02:09:34
Model: Tapo C500  
Hardware Version: V1
Firmware Version: 1.1.1

The detection feature does not work that well...driving nuts... the camera detects steam movement outside from the wall and sends notifications too frequent, plus it records unvaluable garbage when it detects steam and wind sometimes. I followed best practice and tips based on TP community feedback and the manufacturer.

  0      
  0      
#1
Options
1 Reply
Re:Motion detection nit working as expected, annoying
2023-11-22 11:46:32

  @Razzi 

Hi,
1. On the camera's Device Settings>Detection page, you can tap the enabled detection type and adjust the Sensitivity settings if it is available.
2. On the camera's Motion Detection page, except for the Sensitivity settings, you can also adjust the Activity Zone and check if it helps.
Best Regards

  0  
  0  
#2
Options