1
Votes

Auto return to fix position for Pan/Tilt camera after no movement detected

 
1
Votes

Auto return to fix position for Pan/Tilt camera after no movement detected

Auto return to fix position for Pan/Tilt camera after no movement detected
Auto return to fix position for Pan/Tilt camera after no movement detected
3 weeks ago - last edited 2 weeks ago
Model: Tapo C225  
Hardware Version:
Firmware Version:

I used pan/tilt camera like C225 to track my pets, who has health condition so I want to know where he is and what happaned.

One thing annoying me for C225 is that sometimes it track the movement to a corner and my cat disapeared at a blind spot, and the camera just sit at a awkward angle that normally don't have movement.

 

What I want is that after certain time that there is no motion, the camera should move to a pre-defined postion where it is most likely to capture a new movement.

#1
Options
1 Accepted Solution
Re:Auto return to fix position for Pan/Tilt camera after no movement detected-Solution
3 weeks ago - last edited 2 weeks ago

  @GusThePomelo 

Hi,
Your feature request is the same as this thread, please refer to the suggestions on it to check if it helps.

Best Regards 

Recommended Solution
#2
Options
2 Reply
Re:Auto return to fix position for Pan/Tilt camera after no movement detected-Solution
3 weeks ago - last edited 2 weeks ago

  @GusThePomelo 

Hi,
Your feature request is the same as this thread, please refer to the suggestions on it to check if it helps.

Best Regards 

Recommended Solution
#2
Options
RE:Auto return to fix position for Pan/Tilt camera after no movement detected
3 weeks ago
+1
#3
Options

Information

Helpful: 1

Views: 82

Replies: 2

Voters 1

voter's avatar