Smart Home Community > Tapo Smart Camera > Tapo C200 Stuck with Night Mode Lights On
< Tapo Smart Camera

Tapo C200 Stuck with Night Mode Lights On

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Tapo C200 Stuck with Night Mode Lights On

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Tapo C200 Stuck with Night Mode Lights On
Tapo C200 Stuck with Night Mode Lights On
2025-03-22 12:58:52 - last edited 2025-04-02 12:38:05
Model: Tapo C200  
Hardware Version:
Firmware Version:

Hi,

 

I recently powered on my TP Link C200 and while it was working for a while it is now stuck with the four night mode lights on permanently.

 

I have tried to press the reset button for 5 seconds (and longer) however this does not get any response from the device.

 

It is not broadcating an SSID for setting up with the app.

 

Power cycling the device does not boot properly but goes straight back to showing the night mode lights.

 

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Tapo C200 Stuck with Night Mode Lights On-Solution
2025-03-24 12:31:03 - last edited 2025-04-02 12:38:05

  @Alan_Moore 

Hi,
You can check if the suggestions in the following instructions will be helpful.
What to do if my Tapo Camera gets bricked after a firmware update?
 

If the problem remains, you can contact your retailer or our local team to check if your camera is under warranty.

 

Best Regards
 

>> Smart Home: Introduction to Common Smart Action Scenarios for Tapo Cameras >> Tapo Camera Day/Night Mode Selection Guide: Best Settings Recommendations for Different Scenarios >> What should I do if my Tapo camera triggers false detection? >> Enhance Your Tapo App Experience: Introduction to Several Practical Features
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Tapo C200 Stuck with Night Mode Lights On-Solution
2025-03-24 12:31:03 - last edited 2025-04-02 12:38:05

  @Alan_Moore 

Hi,
You can check if the suggestions in the following instructions will be helpful.
What to do if my Tapo Camera gets bricked after a firmware update?
 

If the problem remains, you can contact your retailer or our local team to check if your camera is under warranty.

 

Best Regards
 

>> Smart Home: Introduction to Common Smart Action Scenarios for Tapo Cameras >> Tapo Camera Day/Night Mode Selection Guide: Best Settings Recommendations for Different Scenarios >> What should I do if my Tapo camera triggers false detection? >> Enhance Your Tapo App Experience: Introduction to Several Practical Features
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 375

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.