Hi @MauriceGee It supports SDN like other omada switches, no difference. The limitation is for all SDN switches. Once they are managed by SDN, some of the Standalone Advanced settings will not be...

Hi @Patrick8277 Yes we need to change the DNS for both WAN to make Link Backup work properly for you. There is no limitation on DNS servers you use. I agree 8.8.8.8 and 1.1.1.1 are good choice.

Hi @Spryde To figure out the issue, I'd like to escalate your case to the TP-Link support team for further troubleshooting. They will reach you via your registered email address shortly, please pay...

Hi @Matuy 1. Replace the Ethernet cable from PoE injector to the CPE; 2. Update the firmware

Hi @Murodjon The vlan_trunk command is used to enable VLAN Trunk for the desired port. When enabled, all packets in VLANs will pass through this port. For example: Switch(config)#interface...

Hi @Bebe1980 Create a new "Site" on the controller and move these two APs into new site; Then do the Wireless settings with WLAN Schedule, to disable the wireless radio every night.