@Fabfab74 On the WAN settings, in normal case we don't need to set up Static IP. Most of the ISP use Dynamic IP or PPPoE. You will need to check it with your ISP. Just make sure the router WAN port...

@mamarcos Hi I had a test with our router in lab but can't find the same issue. Firmware Build 20220114 You may check: 1. If your router WAN has a public IP? 2. Is there any VPN server setup? 3....

@Mt.Faith May I know the VLAN interface is set up on your Router, or on the switch? If the switch only have VLAN settings, it should not influence the IPv6 and routing; If the switch also have VLAN...

@Pascal Currently we can only use one Omada controller in one subnet. I will report your requirement to the related department. Temporary solution: If possible, use your Router/switch to build a...

@devzer0 LAG Table will not show anything if the switch ports are not connected to another LAG device. Once LAG take effect you will see the member ports. https://www.tp-link.com/en/support/faq/991/...

@Timberock -94dBm is not a good signal strength. Please check if the AP-Client units have a clear sight between them. And the antenna should be "face-to-face". Other factors:...