@DanieleDB Hi, You cannot have a Mesh network with Ethernet Backhaul between the Archer AX55 Pro and the RE700X. None of the two devices supports this feature as of today. But you can keep an eye on...

@Marzuq Hi, What are you trying to connect to LAN1? What is the device's maximum supported speed? If it's a device that supports 10Gbps, then yes, you should use a cable that supports 10G, normally...

@MikeLieberman I would reset the router to factory default settings by pressing and holding the small "Reset" button on the back of the router (hold until all LEDs turn on momentarily) and then check...

@PaulB1 Ok, it's good to hear that the router's Wi-Fi gets flagged [EasyMesh] after the scan, but it's bad that the RE900XD adds the _EXT in the following step. From the screenshot you posted it...

@MrDoctor There are no settings that need to be adjusted to make a TL-WN823N work. It should just work after installing the driver. Can you think of any electronic devices that might be causing RF...

@healthboost213 If "WAN IP binding = ON" results in the DDNS IP address being 10.209.xxx.xxx, then it means the WAN IP address of your Archer C6 router is 10.209.xxx.xxx. As long as the WAN IP...