woozleLV6Offline
Following: 0Followers: 26
Forums/ Wi-Fi Routers
2024-04-11 18:03:57
Re:AGAIN openVPN doesnt work
@awsick Hi, I noticed that your WAN interface is connected to a network using private IP addresses. Is the VPN client located inside that 10.x.x.x network? Or have you setup port forwarding on the...
0HELPFULS
Forums/ Wi-Fi Routers
2024-04-11 17:22:17
Re:EasyMesh Routers Support Building a EasyMesh Network via Ethernet Backhaul NOW
@TiagoGiovanaz Hi, I can't say anything about the Archer AX10, but the RE305 with firmware version 1.0.23 does definitely not support Ethernet backhaul. The RE315 V1 with firmware version 1.0.30 is...
0HELPFULS
Forums/ Adapters
2024-04-11 17:01:58
Re:Doesn't work, driver's can't install
@CzarnyRob Yes, the Archer TXE75E uses an AX210 M.2 module from Intel. It is correct that its name is shown as "Intel(R) Wi-Fi 6E AX210 160MHz". P.S. The Bluetooth of the Archer TXE75E and the...
0HELPFULS
Forums/ Wi-Fi Routers
2024-04-10 18:11:55
Re:wifi speed is less than half
@Zoli15 Hi, Unfortunately the problem can only be solved by replacing the Archer C20 with another router model that has Gigabit Ethernet ports. As you can see here...
0HELPFULS
Forums/ Range Extenders
2024-04-10 18:07:04
Re:is RE205 limiting speed?
@Sauravm22 As I mentioned earlier, any cable rated Cat 5e or better is sufficient for the RE450. (provided your Cat 5e cable is of good quality) The RE450 has a Gigabit Ethernet port....
0HELPFULS
Forums/ Range Extenders
2024-04-10 17:29:42
Re:is RE205 limiting speed?
@Sauravm22 The typical impedance of Ethernet cable is standardized as 100 Ohm. Usually the manufacturers omit the "100 Ohm" marking on their cables. But still, Ethernet cables without a "100 Ohm"...
0HELPFULS
1338339340...