@Larry94 Beta firmware 1.3.1 Build 20250714 rel.49367 has been sent to your device, you may check it later in the Tapo app and perform the update. Before the Upgrade: (1) Please be sure you have read...

@BigE0n Beta firmware 1.3.4 Build 250527 Rel.110651 has been sent to your device. You may check it later in the Tapo app and perform the update. Before the Upgrade: (1) Please be sure you have read...

@Joanlebelle Which switch did you use? Can you share a picture here? Note that the robot vacuum will still need to maintain WiFi connection while in standby mode, which will also consume battery...

@DJ00 Check this article. What to do if my Tapo Camera gets bricked after a firmware update?

@JM99 The camera cannot be installed without WiFi. After the setup, the camera can continue to operate when WiFi and internet are both down. However, if you want to access the camera (watch...

@Damienetjess This camera does not support image inversion due to hardware design constraints that prevent upside-down installation. Tapo C410 is equipped with a PIR sensor, which has a fixed...