I have just installed a fairly simple Omada system at a client's house. BT Fibre Modem -> ER7206 Router -> POE Switch with APs and an OC200 controller. The system is repeatedly going offline, pretty m

Hey TP-Link Community, a couple of months ago I upgraded from a 50MBIT/s fiber connection to a 300MBIT/s connection. With that Upgrade I also had to get a better Switch because my previous one was onl

Hi. After updating Omada Software Controller, it automatically readopts and reconfigures all switches and AP. During this adoption/configuration phase, the switches do not forward anything. Although t

Hi, Unable to get stable Mesh , with ~60db under 2 eap 225 Outdoor in v 5.1.0 Thinking about incompatible firmware from eap 225 and OC 300 Anyone has same issue ? Regards Sam

got a nice little system running with an OC300 couple of poe switches and some EAP225 all running fine THEN VM drop a lease line on me with a static ip address How do i change over from the DHCP setup

Is it possible to restrict inbound NAT rules by TOD? I want to only allow certain NAT's during certain hours. I can't seem to figure out how to tie a Time Range profile to the NAT configuration, if th