C9 V1.0 - Reset LED and Both USB LEDs Light Up Solid Blue Then Router Resets

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

C9 V1.0 - Reset LED and Both USB LEDs Light Up Solid Blue Then Router Resets

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
C9 V1.0 - Reset LED and Both USB LEDs Light Up Solid Blue Then Router Resets
C9 V1.0 - Reset LED and Both USB LEDs Light Up Solid Blue Then Router Resets
2021-04-19 22:36:22
Model: Archer C9  
Hardware Version: V1
Firmware Version: 210107

Just bought this at the thrift store for $5.  Pretty sure it's bricked, which is why it was there to begin with, but worth a shot.

 

As the title says, I power it up and the "reset" LED and both USB LEDs light up solid blue. All other LEDs are off.  Stays that way for about eight seconds and the router resets.

 

I have done the firmware upload reset detailed very well here:

 

https://www.youtube.com/watch?v=AU8RyW82Z2M&ab_channel=RichardLloyd

 

It goes through the entire process just fine, but after it resets after loading the firmware, it goes right back to the above status.  I also tried the previous firmware from current, version 180125.

 

So, is this thing superbricked?  Or is there coming back from this?

  0      
  0      
#1
Options
1 Reply
Re:C9 V1.0 - Reset LED and Both USB LEDs Light Up Solid Blue Then Router Resets
2021-05-05 02:37:31

Threw it away.  Thanks TP-Link community!

  0  
  0  
#2
Options