@Ryan I gave this a test and found that wire backhaul is broken on this version. I have reverted to v1.1.6

  @Ryan I have a BE11000 mesh on the current 1.1/7 build. Of my three nodes, one continually losing connection to the mesh and requires a power cycle to reconnet. I looked at the logs and see nothing with today's date...unless the logs are being based on some other time/date than what I have set up on the mesh.

Ryan wrote

  @Holocron 

 

Did the behavior only begin after updating all of your nodes to 1.1.7?

 

 

  @Ryan I do not specifically recall. I believe it was after 1.1.7.

Ryan wrote

  @Holocron 

 

 

 

Where is this specific node located in relation to the other nodes and your home's layout? Is it particularly far from the other nodes?

 

This specific node is on the 2nd floor, located near the center of the house. There is a node on the 1st floor, to the "south" of the location of the 2nd floor node. It's about 15-20 feet, by my guess without doing the math. The main node is located in the basement level, about 15 feet from the 1st floor node. Spacially, the 2nd floor node (the problem) is maybe 20-25 feet away from the main node in the basement.

Ryan wrote

  @Holocron 

 

 

Have you tried using the Connection Preference feature in the Deco app to assign its Deco-to-Deco connection to a particular node?

Not specifically, as I don't recall that setting for nodes previously. It is currently set to Auto and is connected to the main basement node.