Home

Forums

Stories

Knowledge Base

Home Network Community > All Threads > Just installed new TP router and now can no longer manage existing TP access point with tp-link

< All Threads

Just installed new TP router and now can no longer manage existing TP access point with tp-link

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Just installed new TP router and now can no longer manage existing TP access point with tp-link

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

rxb

2022-05-02 13:27:01 - last edited 2022-05-24 06:23:19

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-05-02

Just installed new TP router and now can no longer manage existing TP access point with tp-link

2022-05-02 13:27:01 - last edited 2022-05-24 06:23:19

Model: TL-WR841N

Hardware Version:

Firmware Version:

A few months ago I installed a TL-WR841N as an access point for a room that gets poor reception from the wireless router. I just replaced that router - an old Airport - with an AX-3000. That works fine. But now when I go to TP Link it defaults to managing the new router, and I'm unable to manage the access point. While I don't have an urgent need to do that now, it would be great to know how if and when I need to. Any advice welcome!

1 Accepted Solution

Kevin_Z

2022-05-24 06:23:10 - last edited 2022-05-24 06:23:19

Posts: 21544

Helpful: 5004

Solutions: 2536

Stories: 21

Registered: 2018-12-24

Re:Just installed new TP router and now can no longer manage existing TP access point with tp-link -Solution

2022-05-24 06:23:10 - last edited 2022-05-24 06:23:19

Hello @rxb

Are you managing the two devices in the local network or remotely? If you are managing them in the local network, please check and ensure they are not using the same IP address for the management, you may change the IP of the WR841N to 192.168.0.2 if the IP of the AX3000 is 192.168.0.1.

You can refer to the story below to check which case yours belong to, then check the solutions accordingly:

How to Login to Web Interface of TP-Link Router in Access Point Mode

If you are managing them from a remote network, you can check this story instead:

Remotely accessing the secondary router in a double NAT topology

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Information

Helpful: 0

Replies: 1

Just installed new TP router and now can no longer manage existing TP access point with tp-link

Just installed new TP router and now can no longer manage existing TP access point with tp-link

Information

Voters 0

Tags