Home Network Community > All Threads > Deco X60 slow speeds with 300Mbps connection
< All Threads

Deco X60 slow speeds with 300Mbps connection

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco X60 slow speeds with 300Mbps connection

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco X60 slow speeds with 300Mbps connection
Deco X60 slow speeds with 300Mbps connection
2022-10-09 19:33:52
Model: Deco X60  
Hardware Version: V2
Firmware Version: 1.5.1 Build 20210204 Rel. 50164

I just had a 300Mbps fiber Spectrum Modem installed. Running the speed test in the Deco app shows speeds consistent with that (336.7Mbps). When I run a speed test on my network (after the Deco) I only have about 120-130 Mbps. 
 

I noticed if I prioritize anything the speed drops to half that, so nothing is set there. I have QoS Bandwidth set higher than my anticipated speeds. 
 

I use four Deco X60 units in my network.


What else can I do to resolve this?

  0      
 
  0      
 
#1
Options
2 Reply
Re:Deco X60 slow speeds with 300Mbps connection
2022-10-11 00:44:28

  @dmalerba,

How are you running the speedtest on your network? It is common to see dropoffs if you are testing wirelessly, as the speeds can be significantly slower than a hardwired connection. Also, there could be bandwidth that is being used by other devices on your network. 

Check out the Latest: Getting Started with EasyMesh and TP-Link New Tablet Mode for the Tapo App Comparing the Latest Tapo Doorbells
  0  
  0  
#2
Options
Re:Deco X60 slow speeds with 300Mbps connection
2022-10-11 01:40:09 - last edited 2022-10-11 01:40:51

  @Riley_S 

running wirelessly, however this is not a dropout. It NEVER gets anywhere close to where it should be. 


One issue was I had prioritized a connection to a solar array which uses the 2.4 band. This slowed the entire network to speeds around 56Mbps. I thought it was just my lousy service, but just got fiber and it made no difference. After I removed that, it went to the speeds I mentioned earlier (~150Mbps) ALL of the time. 
 

I had 4 X60's in use. I took 1 off yesterday. I now am getting speeds around 350Mbps. 
 

I'm less than thrilled with the performance of these, I have to constantly "optimize" and pretty regularly have to reboot them all.

 

 I had a total of 6 X60's, not all in use, I returned 3 today & am seriously considering returning the other 3 too.

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 440

Replies: 2

Related Articles
SLOW Deco X60/M5 WiFi/LAN Speeds
689 2
Deco m9, slow wired connection speeds
823 2
Deco X60 Errors - Slow Internet
1345 0
Deco X60 Fast Roaming causes slow speeds on Samsung S20 phones
761 0
Deco x60 - No 2402 mbps speeds on 5Ghz?
663 0
CM3000 Not Getting 2GB Speeds to Deco x60
143 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.