Future Consideration Possibility to change WiFi channels
There should be a way to change WiFi channel, or at least the system should change it by itself, choosing the least saturated one. For 2.4GHz it is clear that it will be almost impossible to select a free channel, but on the 5GHz I only see other 2 networks and we are all in the same channel! For at least one the reason may be that our neighboor is using a TP-Link product as well.
I think this is a very basic configuration in any WiFi device, which I would have never though was not going to be possible before buying it.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@David-TP My DECO M4 set as AP mode as I add in DECO m4 to to my current home network , when I start the DECO with my mobile, it does not prompt for TP_LINK ID and just display a screen then with deco app Could it be wrong of my setup.
Thanks
- Copy Link
- Report Inappropriate Content
@David-TP , I am really disappointed that this feature is not available and I probably would not have bought my Deco W7200 if I had known this ahead of time. One of the main reasons this is important to me is that I use home assistant and a zigbee network to communicate with different sensors. The zigbee network overlaps with the wifi network that my Deco chooses so I have constant drops in my sensors because I cannot choose a wifi channel that is lower to reduce this effect. PLEASE, correct this issue!!!
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Until TP-Link sets up the ability to set the 2.4 GHz channel and also set channel width to be 20 MHz (instead of the 40 MHz they currently use), why not setup your zigbee network on channel 25 or 26? As seen in the diagram below, these are very unlikely to be interfered with by WiFi, even if WiFi uses channel 11 at 40 MHz width.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@jcsogo Disappointed in my newly-bought Deco X55's inability to let me select the least congested channels. It auto-chooses the MOST congested and MOST active channels - you can guess the impact on performance. In case TP-Link haven't noticed, it's now 2023 and way past time that this basic setting is available. I've gone back to my old Telstra SmartModem2 + three ethernet-connected SmartModem2's configured as access points, which gives me much better speed that I can get with TP-Link.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 125
Views: 61649
Replies: 190