@Sunshine 

Sunshine wrote

  @solocal 

Hi,

 

The new firmware Archer MR600(EU)_V2_220826 still supports 4G+.

It defaults to using 4G for low-bandwidth network activities and will switch to 4G+ for high bandwidth activities.

Just seen this post. So when you say "It defaults to using 4G for low-bandwidth network activities and will switch to 4G+ for high bandwidth activities." this confirms the numerous complaints that the MR600 constantly switches between 4G and 4G+, and this is actually a bug (and not a feature). Why was this denied by TP Link for years?!

As requested some time before, it would be helpful if TP-Link would provide support to get an OpenWRT version for the MR600 and let the community try and fix TP-Links problems. And remove all spyware/backdoors etc. from TP-Link routers.

Unless you change this I will certainly not recommend any TP-Link products.

Thanks

  @Kevin_Z 

Hi, i need a M7450(EU) V1.1 firmware that can support band lock for connections stability. Please help

  @MobileRouter 

Out of interest, I tested my samsung a25 phone on mobile data - isp tpg/vodafone australia.  It exhibits similar behaviour to my MR600v2 (also TPG -updated to latest EU FW).

When Idle or low traffic, the icon on samsung goes from 4g+ to 4g after a minute.  Then when playing internet radio etc, 4g becomes 4g+.  This is exactly what I'm seeing on the MR600.

Older MR600 firmwares (pre v1.7) don't sync the 4g+ LED to the actual 4g state (as shown in advanced status ) it seems. 

  @Kevin_Z 

Hola Tengo un TL-MR6400 en lo cual al parecer no esta reconociendo el chip, adicional a eso quise actualizar el firmware sin exito me podrias ayudar por favor soy de Peru , la version del equipo es la V.2 la version del firmware es: 

Hello, I have a TL-MR6400 which apparently is not recognizing the chip, in addition to that I tried to update the firmware without success, could you help me please, I am from Peru, the version of the device is V.2 the firmware version is:

  @Kevin_Z 

Hello, i have a TL-MR150(EU)V2 with installed Firmware Version:‪1.3.0 0.9.1 v0001.0 Build 210629 Rel.62159n

Hardware Version:‪TL-MR150 v2 00000001

In general no problems with it, but sometimes it switches from band 7(high speed in my area) to band 3(much slower), so i need manual band selection which my firmware (1.3.0 0.9.1) doesnt have.

Upgrade to beta fw from this thread is impossible (maybe because it has older date (20200930)) and gives error 4503 while upgrading attempt.

Today i noticed that my router webgui is showing an update option - a new fw (1.4.0 0.9.1 v0001.0 Build 240719 Rel.39500n)

I could not find any info on this new version, does it have a band selection option or not?

Or maybe there is some other fw with band selection that can be installed on my router that i dont know about?