MR200 v2 band selection firmware please
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
MR200 v2 manual band selection firmware please.
I can't select band in in my device.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, MR200 V2 seems to be an old version, which was released years ago, may I know when did you purchase it? We cannot guarantee that there will be a new firmware for it to allow the band selection.
However, you can check this with the local tech support to confirm if they could advise.
- Copy Link
- Report Inappropriate Content
Hi, I am afraid that there is no beta firmware for Archer MR200 V2 which could manually select the band yet.
- Copy Link
- Report Inappropriate Content
Is there another newer firmware? the last is from dec 2018. is the hardware onemesh compatible? would be great.
- Copy Link
- Report Inappropriate Content
Hi, MR200 V2 seems to be an old version, which was released years ago, may I know when did you purchase it? We cannot guarantee that there will be a new firmware for it to allow the band selection.
However, you can check this with the local tech support to confirm if they could advise.
- Copy Link
- Report Inappropriate Content
@Balapv I think MR200 V2 is 2016 model but I got mine in 2017.
Kind regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1762
Replies: 4
Voters 0
No one has voted for it yet.