Official Release Deco M4(V4) 1.1.0
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello everyone,
I'm happy here to announce that the official firmware for Deco M4 V4 that allows choosing the signal source and connection preference is now available.
Deco M4_V4_1.1.0 Build 20230112
More details about New Features/Enhancement: 1. Support for customizing Satellite Deco signal source. 2. Support for customizing Clients connection preference. 3. Support for Reboot Schedule. 4. Support for NO-IP and DynDNS. 5. Support for setting Effective Time and Bandwidth Limit for guest network. 6. Support detection of WAN-side Ethernet cable specifications and prompts for exceptions in the app. 7. Support IPv6 plus and Dual-Stack Lite. 8. Added Smart DHCP switch under Access Point mode.
Notes:
1. Please update your Deco APP to the latest version for the new features.
2. If there are non-1.6.0/1.1.0 models in the Mesh network, you may miss some new features but this feature will be supported via firmware update in the future.
3. You may miss some new features when Deco is set to Access Point mode.
Related Articles:
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@David-TP i have successfully updated my 3 M4 hardware v4 to this firmware. I need another deco device to get better coverage. Will a single M4R hardware v1 work in this setup?
- Copy Link
- Report Inappropriate Content
Hi @Moral3s,
Did you manage to downgrade to 1.0.2?
I've been trying as well but it's still on version 1.1.0
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@David-TP Still no news on the update for the older M4's? v2 specifically?
- Copy Link
- Report Inappropriate Content
Anyone else find 1.1.0 to be unstable? Many devices seem to have trouble connecting to the mesh after a few hours and the mesh needs ot be rebooted?
I have a mix of M4 w/ 1.1.0 and M5 w/ 1.6.1.
Are you planning on fixing the Deco M4?
- Copy Link
- Report Inappropriate Content
@coolspot18 yes same here. I have 3 M4 and 1 M4R (different hardware version with 1.5)
- Copy Link
- Report Inappropriate Content
@Papaey M4R is the name for all Deco M4 models.
Check the bottom of your M4. It should say "Ver.: 2.0" or something like that. That's the hardware version.
- Copy Link
- Report Inappropriate Content
@David-TP Is there a beta 1.6.x for Deco M4 V4?
- Copy Link
- Report Inappropriate Content
@David-TP Still no news on the update for the older M4's? v2 specifically?
- Copy Link
- Report Inappropriate Content
@David-TP Any news regarding the update for the older hardware revisions?
Now that the weather is getting nicer again, the air somehow seems to carry wifi-signals better and my garage Deco sometimes (once or twice a week lately) decides to connect wirelessly instead of via the powerline ethernet... And then the poweline system connects "backwards" and everything becomes slow as hell.
I'd love to remedy the situation by manually configuring how the decos are supposed to connect. It's not exactly reasonable to have to fight a broken mesh system every once in a while 
And of course it always happens at the most critical moments...
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 24977
Replies: 35
Voters 2
