I recently purchased Tapo Hub H200 so that I can use it to store my Tapo Camera recorded videos using the hub's micoSD card.

I have the following cameras:

1. 2 Tapo C320WS (Hardware version: 2.0, Firmware: 1.3.5)

2. 1 Tapo C510W (Hardware version 1.0, Firmware: 1.3.3)

3. 1 Tapo C212 (Hardware version 2.0, Firmware: 1.4.6)

Previously I had updated the firmware on my cameras and found that they now support storing recorded videos on a hub. Hence, I went ahead to purchase Tapo Hub H200.

My cameras have been working fine since a few months. Also, I had set up the hub (it displays a green led now) and is connected to my network using both Ethernet & Wifi.  

However, when I'm trying to set the cameras to save their videos to the hub, they're not able to find the hub (I get message "No available hubs").

The hub and the cameras are connected to the same network.

I read the following page https://www.tp-link.com/in/support/faq/4191/ and I understand that my cameras should support recording to the hub.

Hence, I find it quite dissapointing that my cameras are not able to locate the hub. 

Kindly help me with a resolution.