Home Network CommunityDecoUnable to connect. Open wifi Decco4422 kept hanged at blue light (blinking condition)
Deco

Unable to connect. Open wifi Decco4422 kept hanged at blue light (blinking condition)

Unable to connect. Open wifi Decco4422 kept hanged at blue light (blinking condition)

Unable to connect. Open wifi Decco4422 kept hanged at blue light (blinking condition)
Unable to connect. Open wifi Decco4422 kept hanged at blue light (blinking condition)
Yesterday
Tags: #Network Connectivity #Firmware Update #Access Point Mode
Model: Deco X20-4G  
Hardware Version: V2
Firmware Version: AX1800

Unable to connect. Open wifi Decco4422 kept hanged at blue light (blinking condition

0
0
#1
2 Reply
Re:Unable to connect. Open wifi Decco4422 kept hanged at blue light (blinking condition)
8 hours ago

  @SunShineHead 

 

See if the troubleshooting steps in the following FAQ help if not please reply back to this post.

 

Thanks 

 

 

Need help with the Deco app, setup, Ethernet backhaul, network switch or rolling back firmware? Router or AP mode? https://community.tp-link.com/us/home/forum/topic/699816?page=1
0
0
#2
Re:Unable to connect. Open wifi Decco4422 kept hanged at blue light (blinking condition)
3 hours ago

  @SunShineHead 

Hi, 
You can refer to the instructions below to set up the Deco X20-4G.
How to Set Up a 4G/5G Whole Home Mesh Wi-Fi Router (Take Deco X50-5G as an Example)
 

If you fail to set up the Deco, refer to this post to troubleshoot.

Best Regards

>> Smart Home: Introduction to Common Smart Action Scenarios for Tapo Cameras >> Tapo Camera Day/Night Mode Selection Guide: Best Settings Recommendations for Different Scenarios >> Enhance Your Tapo App Experience: Introduction to Several Practical Features >> Troubleshooting for Tapo Camera's Privacy Mode Automatic Activation
0
0
#3

Information

Helpful: 0

Views: 47

Replies: 2

Tags

Network Connectivity Firmware Update Access Point Mode
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.